Vpls Configuration Task List; Enabling L2Vpn And Mpls L2Vpn; Configuring Ldp Vpls; Configuration Prerequisites - HP 12500 Series Configuration Manual

VPLS configuration task list

Complete the following tasks to configure VPLS:
Task

Configuring LDP VPLS

Configuring BGP VPLS
Binding a VPLS instance
Configuring VPLS and MAC-in-MAC dual-stack support
Configuring MAC address learning
Configuring VPLS instance attributes
Configuring traffic policing for an AC
Inspecting PWs
NOTE:
When STP is enabled globally, the switch cannot transmit STP's Bridge Protocol Data Units (BPDUs) on a
VPLS PW.

Enabling L2VPN and MPLS L2VPN

Enable L2VPN and MPLS L2VPN before you perform VPLS related configurations.
To enable L2VPN and MPLS L2VPN:
To do...
Enter system view
Enable L2VPN and enter L2VPN view
Enable MPLS L2VPN
NOTE:
For detailed information about the l2vpn command and the mpls l2vpn command, see
Reference
.
Configuring LDP VPLS

Configuration prerequisites

Before you configure LDP VPLS, complete the following tasks:
Configure an IGP on the MPLS backbone devices (PEs and P devices) to guarantee the IP
•
connectivity of the MPLS backbone. For configuration information, see Layer 3—IP Routing
Configuration Guide.
Remarks
Configure either type of VPLS as needed
Required
Optional
Optional
Required
Optional
Required
Use the command...
system-view
l2vpn
mpls l2vpn
132
Remarks
—
Required
Required
MPLS Command