Resetting The Speedtouch™610 Via Its Web - THOMSON SpeedTouch 610 Operation And Maintenance Manual

9 Resetting the SpeedTouch™610
9.1 Resetting the SpeedTouch™610 via its Web
Introduction
Preconditions
Procedure
62
Pages
This method is most useful in case you want to revert to SpeedTouch™610 default
settings while configuring the SpeedTouch™610 via its web pages, without losing your
current IP connection to the device.
You can reset SpeedTouch™610 configurations back to their initial state, with the
exception that IP configurations directly assigned to the SpeedTouch™610 Ethernet
interface are preserved, i.e. the one or - optionally - more IP address configurations on
interface eth0 of the SpeedTouch™610 are not affected.
To be able to use the method described below you must:
•
Have access to the SpeedTouch™610 web pages
•
If required, know the System Password.
Proceed as follows to reset your SpeedTouch™610 via its web pages:
Open a web browser and go to the SpeedTouch™610 web pages:
1
Open the Upgrade page via System Config - Upgrade.
2
On this page you can find the Configuration box:
E-SIT-CTC-20030324-0002 v1.0