THOMSON SpeedTouch 610 Operation And Maintenance Manual page 26

3 SpeedTouch™610 System Software
Mark system software
file as Passive Software
Version
Activate the upgrade/
restored system
software
24
You must identify the system software you transferred to the SpeedTouch™610 '/dl'
subdirectory as passive software version to allow the SpeedTouch™610 to mark the file
as system software.
Proceeding from the same FTP session you opened to transfer the file, execute the
quote site software setpassive file=<file name> command, where <file name> represents
the name of the system software file you transferred via the previous procedure:
ftp> quote site software setpassive file=LLT5AA4.20G
200- Flash image : 4.2.0.15
200- Active SW : LLT5AA4.20F
200- Passive SW : LLT5AA4.20G
200-
200 CLI command "software setpassivefile" executed
ftp>
To activate the upgrade or restored system software, the same mechanism as used via
the web pages is valid: the system software files are switched.
Proceeding from the same FTP session you opened in the previous procedures, execute
the quote site software switch command to restart the SpeedTouch™610 and activate the
newly uploaded upgrade system software:
ftp> quote site software switch
200-
Connection closed by remote host.
ftp>
During restart, the SpeedTouch™610 will switch the passive and active system software
files and mark the newly uploaded system software as active software version.
Due to the restart of the SpeedTouch™610 any open FTP or Telnet session will be
closed.
E-SIT-CTC-20030324-0002 v1.0