Menu-Driven Cli Navigation - THOMSON SpeedTouch 610 Operation And Maintenance Manual

Business dsl routers release r4.2

Hide thumbs Also See for SpeedTouch 610:

Table of Contents

7 SpeedTouch™610 Command Line Interface

7.2.1 Menu-driven CLI Navigation

Introduction

Entering the CLI menu

Executing commands

Saving the configuration

To improve the user-friendliness of the SpeedTouch™610 CLI, the CLI features a menu-

driven interface.

To enter the menu-driven interface, simply execute menu from the CLI prompt:

The semi-graphical CLI offers you an attractive and easy-to-use configuration environ-

ment for the CLI.

You can browse through the CLI command groups via the arrow keys. Pressing ENTER

executes your selection, i.e. for entering a CLI command group. From each level you

can select .. and press ENTER to go up one level.

Use TAB to change from the command menu to the control menu (the lower bar of the

menu) and vice versa.

To setup a CLI command, simply press ENTER on its name. You can configure and over-

view its various parameters at once. In case the parameter provides preset values, scroll

through the available values via the UP and DOWN arrow keys. If you are satisfied with

all parameter values, use TAB to go to <OK> and press ENTER to execute the

command:

After configuring the SpeedTouch™610 via the CLI, it is advised to save your configura-

tion. Save the complete SpeedTouch™610 configuration to persistent memory by

executing saveall after exiting the menu-driven CLI via <Cancel> from root menu.

For more information on saved configurations, see

Note

Configuration Management" on page

"5 SpeedTouch™610

31.

E-SIT-CTC-20030324-0002 v1.0

Table of Contents