THOMSON SpeedTouch 610 Operation And Maintenance Manual page 44

5 SpeedTouch™610 Configuration Management
Applying a configuration
stored on the
SpeedTouch™610
42
In case the configuration file you intend to upload has the same name as (one of)
6
the configuration files on the SpeedTouch™610 permanent storage (e.g. user.ini),
you must either:
•
Rename the file name of the configuration file stored on your local disk
•
Rename the file name of the configuration file stored on the Speed-
Touch™610 permanent storage (As shown in the example below)
•
Delete the file from the SpeedTouch™610 permanent storage.
Put the configuration file to the SpeedTouch™610 '/dl' subdirectory (:
7
ftp> put config.ini
200 Connected to 10.0.0.1 port 1657
150 Opening data connection for config.ini
##
226 File written successfully
ftp: 4472 bytes sent in 0.02Seconds 223.60Kbytes/sec.
ftp>
You can check whether the configuration file was stored successfully by making a
8
listing of the subdirectory's contents:
ftp> dir
200 Connected to 10.0.0.1 port 1658
150 Opening data connection for /bin/ls
-rwxrwxrwx 1 0
-rwxrwxrwx 1 0
-rwxrwxrwx 1 0
-rw-rw-rw- 1 0
-rwxrwxrwx 1 0
-rw-rw-rw- 1 0
-rw-rw-rw- 1 0
-rwxrwxrwx 1 0
-rwxrwxrwx 1 0
226 Options: -l
ftp: 597 bytes received in 0.21Seconds 2.83Kbytes/sec.
ftp>
To activate a configuration file, stored on the SpeedTouch™610 '/dl' subdirectory, the
CLI command config load is used.
Below the syntax of the config load CLI command is provided:
=>help config load
Loads saved or default configuration.
Syntax : load [load_ip = <{no|yes}>] [defaults <{no|yes}>]
[flush = <{yes|no}>] [echo = <{no|yes}>]
[filename = <string>]
...
[config]=>
Following parameters are provided:
•
load_ip = <{no|yes}>
Allows you to define whether the current IP configuration should be preserved
(no), or the IP configuration as defined in the loaded configuration file should be
applied (yes). If not specified, load_ip=no.
•
defaults = <{no|yes}>
Allows you to reset the SpeedTouch™610 to its default configuration (yes). If not
specified, defaults=no. To load a configuration file, do not use this parameter.
0 2316185 Jun 29
0
0 13305 Jun 29
0 17616 Jun 29
0 11503 Jun 29
0 256 Jun 29
0 256 Jun 29
0
0 4472 Jun 29
: 9 matches total
1971 LLT5AA4.20K
20 Jun 29 1971 start.cmd
1971 user.ini
1971 user.tpl
1971 temp.cfg
1971 SIP.swk
1971 IPSEC_VPN.swk
0 Jun 29 1971 ss_p12.dat
1971 config.ini
E-SIT-CTC-20030324-0002 v1.0