16.15.9
Positioning multitool
You can position a magazine. In this case, a magazine location is positioned to the loading
point.
Multitools, which are located in a spindle, can also be positioned. The multitool is rotated and
therefore the multitool location involved is brought into the machining position.
Procedure
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
1.
The magazine list is opened.
2.
Position the cursor at the multitool location, which you wish to
bring into the machining position (the multitool is located in the
spindle).
3.
Press the "Position multitool" softkey.
If the cursor is at a multitool location of a multitool, which is
located in the spindle, the multitool location is positioned to the
machining position.
Tool management
16.15 Working with multitool
691