Selecting A Block - Siemens SINUMERIK 840D sl Operating Manual

12.6

Selecting a block

You have the option of setting the interrupt pointer to the current cursor position. The next
time the program is started, processing will resume from this point.
With teach-in, you can also change program areas that have already been executed. This
automatically disables program processing.
You must press reset or select a block to resume the program.
Requirement
The program to be processed is selected.
Proceed as follows
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
1. Select the "Machine" operating area.
2. Press the <AUTO> key.
3. Press the <TEACH IN> key.
4. Press the "Teach prog." softkey.
5. Place the cursor on the desired program block.
6. Press the "Block selection" softkey.
Teaching in a program
12.6 Selecting a block
599