Correcting A Program - Siemens SINUMERIK 840D sl Operating Manual

4.5

Correcting a program

As soon as a syntax error in the part program is detected by the controller, program
execution is interrupted and the syntax error is displayed in the alarm line.
Correction possibilities
Depending on the state of the control system, you can make the following corrections using
the Program editing function.
● Stop mode
● Reset mode
Requirement
A program must be selected for execution in "AUTO" mode.
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Only program lines that have not yet been executed can be edited.
All program lines can be edited.
Note
The "program correction" function is also available for execute from external; however,
when making program changes, the NC channel must be brought into the reset state.
Machining the workpiece
4.5 Correcting a program
131