Parameter
Description
ZD
- (only for ∇ machining)
- (only for unmachined part description, cylinder and allowance)
Allowance
Allowance for pre-finishing - (only for ∇∇∇)
U1
Compensation allowance in X and Z direction (inc) – (only for allowance)
Set machining area
Set machining area limits
limits
with limited machining area only, yes:
XA
1. Limit XA ∅
XB
2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)
ZA
1. Limit ZA
ZB
2. Limit ZB (abs) or 2nd limit referred to ZA (inc)
N
Number of grooves
DP
Distance between grooves
* Unit of feedrate as programmed before the cycle call
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
For unmachined part description, cylinder
–
Version, absolute:
Cylinder dimension (abs)
–
Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
For unmachined part description, allowance
–
Allowance on the CYCLE62 finished part contour (inc)
Yes
U1 contour allowance
No
Positive value: Compensation allowance is kept
Negative value: Compensation allowance is removed in addition to finishing
allowance
Yes
No
Programming technology functions (cycles)
8.3 Contour turning
Unit
mm
mm
mm
mm
mm
383