Interface Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R
Use these commands to configure basic port settings.
24.1 Command Summary
The following section lists the commands for this feature.
Table 63 interface Command Summary
COMMAND
show interfaces <port-list>
no interface <port-number>
show interfaces config <port-list>
interface port-channel <port-list>
inactive
no inactive
name <port-name-string>
speed-duplex <auto|10-half|10-
full|100-half|100-full|1000-
full>
flow-control
no flow-control
qos priority <0-7>
frame-type
<all|tagged|untagged>
pvid <1-4094>
Ethernet Switch CLI Reference Guide

Interface Commands

DESCRIPTION
Displays the current interface status.
Clears all statistics for the specified port.
Displays current interface configuration.
Enters config-interface mode for the specified port(s).
Disables the specified port(s) on the Switch.
Enables the port(s) on the Switch.
Sets a name for the port(s).
port-name-string: up to 64 English keyboard
characters
Sets the duplex mode (
100 or 1000 Mbps) of the connection on the interface.
Select auto (auto-negotiation) to let the specified
port(s) negotiate with a peer to obtain the connection
speed and duplex mode.
Enables interface flow control. Flow control regulates
transmissions to match the bandwidth of the receiving
port.
Disables flow control on the port(s).
Sets the quality of service priority for an interface.
Choose to accept both tagged and untagged incoming
frames (all), just tagged incoming frames (tagged) or
just untagged incoming frames on a port (untagged).
Note: Not all switch models support accepting
untagged frames on a port.
The default PVID is VLAN 1 for all ports. Sets a PVID in
the range 1 to 4094 for the specified interface.
24
half or full ) and speed ( 10
M P
E 3
E 13
E 3
C 13
C 13
C 13
C 13
, C 13
C 13
C 13
C 13
C 13
C 13
97