Interface Commands; Interface Port-Channel; Bmstorm-Limit; Figure 116 Wrr Command Example - ZyXEL Communications ES-2024A User Manual

ES-2024A User's Guide

Figure 116 wrr Command Example

ras# configure
ras(config)# wrr
ras(config)# wrr 4 3 2 1

28.10 interface Commands

These are some commonly used commands that belong to the
commands.

28.10.1 interface port-channel

Syntax:
Use this command to enable the specified ports for configuration. Type multiple ports or port
ranges separated by a comma. Ranges of port numbers are typed separated by a dash.
An example is shown next.
• Enter the configuration mode.
• Enable ports one, three, four and five for configuration.
• Begin configuring for those ports.

Figure 117 interface Command Example

ras# config
ras(config)# interface port-channel 1,3-5
ras(config-interface)#

28.10.2 bmstorm-limit

Syntax:
where
<Kbps>
176
interface port-channel <port-list>
bmstorm-limit
bmstorm-limit <Kbps>
Enables broadcast storm control limit on the switch.
Limits broadcast packet traffic the interface receives per second.
group of
interface
Chapter 28 Command Examples