Vdsl Summary; Table 7 Status - ZyXEL Communications VES-1616F-44 User Manual

VES-1616F/1624F-44 User's Guide
The following table describes the labels in this screen.

Table 7 Status

LABEL
System up Time This field shows how long the system has been running since the last time it was
The following fields are related to the VDSL ports.
Port
PayLoad Rate
State
Tx KB/s
Rx KB/s
Up Time
Retrain
The following fields are related to the Ethernet ports.
Port
Link
State
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Poll Interval(s)
Stop
Clear Counter

5.2.1 VDSL Summary

To view VDSL statistics, click VDSL Summary in the Status screen.
54
DESCRIPTION
started.
This identifies the VDSL port. Click a port number to display the VDSL Port Details
screen.
This field displays the upstream and downstream payload rates.
This field shows whether the port is connected (Showtime), not connected (Idle) or
is negotiating a connection (Training).
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has
been up.
Click Retrain to re-establish the line connection.
This identifies the port. Click a port number to display the Port Details screen.
This field displays the speed (10M for 10Mbps, 100M for 100Mbps or 1000M for
1000Mbps) and the duplex (F for full duplex or H for half duplex).
This field displays the STP state of the port. See the Spanning Tree Protocol chapter
for details on STP port states.
This fields displays whether the Link Aggregation Control Protocol (LACP) has been
enabled on the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has
been up.
The text box displays how often (in seconds) this screen refreshes. You may change
the refresh interval by typing a new number in the text box and then clicking Set
Interval.
Click Stop to halt system statistic polling.
Select a port from the Port drop-down list box and then click Clear Counter to erase
the recorded statistical information for that port.
Chapter 5 System Status and Port Statistics