Gvrp Timer; Enable Gvrp - ZyXEL Communications VES-1616F-44 User Manual

leave <msec>
leaveall
<msec>
This command sets the switch's GARP timer settings, including the join, leave and leave all
timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join
message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All
message terminates all registrations. GARP timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800
milliseconds and the Leave All Timer to 11000 milliseconds.
sysname(config)# garp join 300 leave 800 leaveall 11000

34.2.3 GVRP Timer

Syntax:
show vlan1q gvrp
This command shows the switch's GVRP settings.
An example is shown next.
sysname# show vlan1q gvrp
GVRP Support
---------------------
gvrpEnable = YES
GVRP Support

34.2.4 Enable GVRP

Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the switch.
Chapter 34 IEEE 802.1Q Tagged VLAN Commands
= This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time
must be two times larger than Join Timer; the default is 600
milliseconds.
= This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All
Timer must be larger than Leave Timer; the default is 10000
milliseconds.
VES-1616F/1624F-44 User's Guide
261