Table 81 Command Interpreter Mode Summary - ZyXEL Communications VES-1616F-44 User Manual

To enter Enable (or privileged) mode using a read-only account, type
administrator password when prompted (the default is 1234). When you enter Enable mode,
the command prompt changes to the pound sign (
an administrator you automatically enter Enable mode.
The following table describes command interpreter modes and how to access them..

Table 81 Command Interpreter Mode Summary

.
MODE DESCRIPTION
User Commands available in this mode are
a subset of enable mode. You can
perform basic tests and display
general system information.
Enable Commands available in this mode
allow you to save configuration
settings, reset configuration settings
as well as display further system
information. This mode also contains
configure
the
takes you to config mode.
Config Commands available in this mode
allow you to configure settings that
affect the switch globally.
Command modes that follow are sub-modes of the config mode and can only be accessed from within the config
mode.
Config-interface This is a sub-mode of the config mode
and allows you to configure port
related settings.
Config-mvr This is a sub-mode of the config mode
and allows you to configure multicast
VLAN settings.
config-vdsl- This is a sub-mode of the config mode
alarmprofile and allows you to configure VDSL
alarm profiles..
Chapter 32 Introducing the Commands
HOW TO LOGIN/
ACCESS
Default login level for a
read-only account.
Default login level for
the administrator or
accounts with a
privilege of 13 or 14.
Read-only accounts
command which
(with a privilege of 0 -
12) need to type the
enable
and enter the Enable
mode password.
Type
configure
mode.
Type
port-channel
followed by a port
number. For example,
i nterface port-
channel 10
configure port 10 on the
switch.
To enter
enter
a VLAN ID (between 1
and 4094). For
example, enter
to configure multicast
settings on VLAN 2.
Type
alarmprofile
followed by a profile
name. For example,
vdsl-
alarmprofile
test
VES-1616F/1624F-44 User's Guide
enable
). If you log into the command interpreter as
#
PROMPT
sysname>
The first part of the prompt is
the system name. In the CLI
examples in this User's
Guide, the system name is
always "sysname".
sysname#
command
config or
sysname(config)#
in Enable
interface
sysname(config-
interface)#
to
MVR
mode,
sysname(config-mvr)#
mvr followed by
mvr 2
vlan-
sysname(config-
vdslalarmprofile)#
.
and enter the
209