Configuring Dhcp; Table 68 Dhcp - ZyXEL Communications VES-1616F-44 User Manual

VES-1616F/1624F-44 User's Guide

24.2 Configuring DHCP

Click Advanced Application, DHCP in the navigation panel to display the configuration
screen as shown. Use this screen to configure DHCP settings on the swtich.
Figure 88 DHCP
The following table describes the labels in this screen.

Table 68 DHCP

LABEL
Active
VID
DHCP Status
Server
The fields are editable when you select Server in the DHCP Status field.
Client IP Pool
Starting
Address
Size of Client IP
Pool
IP Subnet Mask Enter the subnet mask of the DHCP Server.
Default
Gateway
174
DESCRIPTION
Select this check box to enable the DHCP settings.
Enter the ID number of the VLAN group to which this DHCP settings apply.
Select Sever to set the switch to act as a DHCP server.
Select Relay to set the switch to act as a DHCP relay.
Then set the corresponding fields below.
Specify the first of the contiguous addresses in the IP address pool.
Specify the size, or count of the IP address pool.
Enter the IP address of the default gateway device.
Chapter 24 DHCP