Table 12 Snmp Configuration Screen Fields - Nortel business policy switch 2000 User Manual

168 Chapter 3 Using the console interface
Table 12

Table 12 SNMP Configuration screen fields

Field
Read-Only
Community String
Read-Write
Community String
Trap #1 IP Address*
Community String
Authentication Trap
Autotopology
* The Trap IP Address and Community String fields can be set using a MIB table (in a Nortel Networks proprietary MIB).
The status of the row in the MIB table can be set to Ignore. If the row status is set to Ignore, the fields appear to be set
when viewed from the console terminal; however, no traps will be sent to that address until the row status is set to Valid.
208700-C
describes the SNMP Configuration screen fields.
Description
The community string used for in-band read-only SNMP operations.
Default Value
Range
The community string used for in-band read-write SNMP operations.
Default Value
Range
Number one of four trap IP addresses. Successive trap IP address fields are
numbered 2, 3, and 4. Each trap address has an associated community
string (see Community String).
Default Value
Range
The community string associated with one of the four trap IP addresses (see
Trap #1 IP Address).
Default Value
Range
Determines whether a trap will be sent when there is an SNMP
authentication failure.
Default Value
Range
Allows you to enable or disable the switch participation in Autotopology,
which allows network topology mapping of other switches in your network.
Default Value
Range
public
Any ASCII string of up to 32 printable characters
private
Any ASCII string of up to 32 printable characters
0.0.0.0 (no IP address assigned)
Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
Zero-length string
Any ASCII string of up to 32 printable characters
Enabled
Enabled, Disabled
Enabled
Disabled