Table of Contents
Advertisement
Renumber Stack Units screen
The Renumber Stack Units screen
configured in the stack. When selected, this option identifies the unit number of
each unit in the stack configuration by lighting the corresponding number of (100
Mb/s port) LEDs on each unit for approximately 10 seconds. For example, unit 3
will display three LEDs.
To open the Renumber Stack Units screen:
➨
Figure 88 Renumber Stack Units screen
Current Unit Number
-------------------
[
1
]
[
2
]
[
3
]
[
4
]
Renumbering stack units will cause an automatic Reset to Current Settings to
occur across the entire stack.
the new numbering scheme. Check the stack configuration after the reset to
confirm the desired configuration is set.
Are you sure you want to renumber switches with the new settings?
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu.
Note: This menu option and screen appears only when the switch is
participating in a stack configuration.
Choose Renumber Stack Units (or press n) from the main menu.
Renumber Stack Units
----------------------------
00-60-fd-77-a6-0c
00-60-fd-77-a5-f0
00-60-fd-77-a4-4c
00-60-fd-77-ab-84
(Figure
88) allows you to renumber the units
MAC Address
The current configuration will be adapted to
Press Ctrl-C to return to Main Menu.
New Unit Number
---------------
[
1
]
[
2
]
[
3
]
[
4
]
[ No
]
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
