Before You Configure Trunks; Figure 41 Client/Server Configuration Example - Nortel business policy switch 2000 User Manual

138 Chapter 2 Network configuration

Figure 41 Client/server configuration example

T2
T3
Business
Policy Switch 2000
S2
For detailed information about configuring trunks, see Chapter 3.

Before you configure trunks

When you create and enable a trunk, the trunk members (switch ports) take on
certain settings necessary for correct operation of the MultiLink Trunking feature.
Before you configure your MultiLink Trunk, you must consider these settings,
along with specific configuration rules, as follows:
1
Read the configuration rules provided in the next section,
Trunking configuration
2 Determine which switch ports (up to four) are to become trunk members (the
specific ports making up the trunk). A minimum of two ports are required for
each trunk.
208700-C
FS1
S1
F
F
S3
Policy Switch 2000
rules."
FS2
Business
Policy Switch 2000
T4
Business
S4
T1
T5
Business
Policy Switch 200
"MultiLink
9806EA