Swingarm Inspection; Swingarm Installation - Honda CRF110F Service Manual

INSPECTION
Check the pivot bushings (1 ] for wear or damage.
Check Ihe swingarm for cracks or damage.
INSTALLATION
Inslallthe chain slider (1], boll [2] and nut (31.
Tlghten the nut to the specified torque while holding the
boll.
TORQUE : 5_ 9 N·m (0.6 kgf-m, 4.4 Ibf-ft)
Set the swingarm
f1
J
onto the frame and insert the pivot
boll{21 from Ihe tight side.
Inslall the swingarm pivot nut 131. but do nut tighten
it
yet
Align the holes of the swingarm and shock absorber
lower mount, then install the
bolt
[1] and nut [21.
Tighten the shock absorber iower mounting nut and
swingarm pivot nut to the specified torque.
TORQUE :
Shock absorber
l ower mounting nut: 50 N-m (5.1 kgf-m, 37 IbHt)
Swingarm pivot nut: 59 N-m (6 _ 0 kgf-m, 44 IbUt)
Inslan the following :
- Rear wheel (page 15-9)
- Drive chain (page 3·14).
- Drive chain cover (page 2·7)
Check and adjust the following:
- Drive chain (page 3-13)
- Rear brake (page 3-16)
- Rear suspension (page 3-18)
REAR WHEEUBRAKEISUSPENSION
111
111
15-17