Rear Wheel Installation - Honda CRF110F Service Manual

Wheel center adjustment
Wheel center Place the rim on the work bench.
adjustment is
necessary when
new spokes are
installed.
Place the hub with the left side down and begin lacing
with new spokes.
Adjust the hub position so the distance from the hub
right end surface to the side of the rim is 11 .0
±
1.0 mm
(0.4 3 ± 0.04 in) as shown.
Tighten the spokes in 2 or 3 progressive steps to the
specifi ed torque.
TOOL:
Spoke wrench, 4.5 x 5.1 mm
07701-<l020200
TORQUE: 3.2 N'm (0.33 kgf'm, 2.4 IbHt)
Check the wheel rim runout (page 15-7).
Instalilhe driven sprocket [1
j.
bolts [2] and nuts (3).
Tighten the nuts to the specified torque while holding
the bolls.
TORQUE: 32 N'm (3.3 kgf·m. 24 IbUt)
INSTALLATION
REAR WHEEL/BRAKE/SUSPENSION
11.0± 1.0mm
(0.43 ± 0.04 in)
..~
Apply grease to a new dust seal [1] lips, then install it
, ---::::-- - - ,- " , -- OC----c-- - - - ,
into the left wheel hub.
Install the left side collar
[21
into the left wheel hub.
Install the brake panel assembly
[11
into the right wheel
hub.
15-9