Cylinder Head Installation - Honda CRF110F Service Manual

INSTALLATION
Clean the cylinder and cylinder head mating surface.
Install the dowel pins (1) and a new gaskel(2) onto the
cylinder.
CYLINDER HEADNALVES
Route the cam chain [1] through the cylinder head [2]
~::;;===========,~=::""",,~=~
and install the cylinder head onlo the cylinder.
Apply engine oil to the seating surface and threads of
~=::===;;::~;:;;~::;;;;;:;;;;::;;r=~~
the cylinder head nuts [1]. Install the four washers [2]
and tighten the cylinder head nuts to the specified
torque in a crisscross pattern.
TORQUE : 13 N'm (1 .3 kgf'm, 10 IbUt)
Install and lighten the cylinder head mounting bolts [3}.
Install a new gasket [1J onto the cylinder head.
Set the wire guide (2) to the intake pipe [3] and tighten
the two bolts [4] to the specified torque.
TORQUE: 12 N'm (1.2 kgf-m , 9lbHt)
Connect the spark plug cap 15].
Install the following :
- Cam sprocket (page 8-9)
- Exhaust pipe/muffler (page 2-8)
8-19