Rear Wheel Inspection; Rear Wheel Disassembly; Axle; Wheel Rim Runout - Honda CRF110F Service Manual

INSPECTION
Axl.
Set the axle [11 on V-blocks and measure the runout.
The actual runout is 1/2 of the total indicator reading.
SERVICE LIMIT: 0.20 mm (0.008 in)
Wheel bearing
Tum the inner race of each bearing with your finger.
Bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tlghtly in the
hub.
Rep/aCfJ the wheel
Remove and discard the bearings if the races do not
bearings
in pairs. lurn smoothly and quietly,
or if they fit
loosely in the
hub.
Install Ihe new bearings into the hub using the special
lools (page 15-8).
Wheel rim runout
REAR WHEEUBRAKE/SUSPENSION
Check the rim runou! by placing the wheel in a trueing , - - - - -- - -- - - - - - - - - ,
stand.
Spin the wheel by hand, and read the runou! using a
dial indicator.
SERVICE LIMITS :
Radial: 1.0 mm (0.04 in)
Axial : 1.0 mm (0.04 in)
DISASSEMBLY
Remoye the driven sprocket nuts [1], boils [2J and
driven sprocket [3).
8
15·7