Omron CS CJ1W-ETN21 Operation Manual page 55

Example Application
2. Destination Mail Address Setup
3. Send Condition Setting 1
Contents of E-mail Body
Attached File Information
Mail Trigger Condition
Settings
Note
Tab
DNS IP Address
Port No.
Retry timer
Tab
Mail Address Mail address 1
Tab
Send Mail Mail address
• Including User-set Data in E-mail Body
Tab
Send Mail Send user data
User defined mail address
• Including Error Log Information in E-mail Body
Tab
Send Mail Send Error Log information
• Including Status Information in E-mail Body
Tab
Send Mail Send status information
Example:
Sending the 10 words of data from W300 to W309 as an attached file called
W300.CSV.
Tab
Send Mail Send file data or I/O memory
data
Attached file name
I/O memory data
• Send on the Rising Edge of the Dedicated Control Bit (Mail Send Switch)
Tab
Send Mail Mail trigger type
The Mail Send Switch is bit 03 of word n in the CIO Area words allocated to
the Ethernet Unit as a CPU Bus Unit. (n = 1500 + 25 × unit number)
• Send when a Specified Word's Value meets a Preset Condition
Example: Send e-mail when the content of D00300 is 500.
Tab
Send Mail Mail trigger type
• Send on the Rising or Falling Edge of a Specified Bit
Item
10.56.3.24
53 (default value)
10 s (default value)
Item
beta@omron.co.jp
Item
Address 1
Item
Selected
Set the leading address of the
words in I/O memory that contain
the user-set ASCII data.
Item
Selected
Item
Selected
Item
Send file data or I/O memory data
selected; I/O data (CSV) selected
W300
Area: W; Address: 0; Size: 10
Item
Bit value change
Item
Word value change
Area: D
Address: 300
Value: 500
State: =
Section 2-9
Setting
Setting
Setting
Setting
Setting
Setting
Setting
Setting
Setting
31