Settings Required For The Mail Send Function - Omron CS CJ1W-ETN21 Operation Manual

Using the Mail Send Function
2-4-2

Settings Required for the Mail Send Function

CX- Setting
Programmer
Unit Setup
Tab
SMTP Server specification
type
IP Address
Host name
Port No.
Local mail address
Use POP before
SMTP
POP Server specification
(See note 1.) type
IP Address
Host name
Port No.
Account Name
Mail password
Server access inter-
val time
DNS IP Address
(See note 2.)
Port No.
Retry timer
Mail Address Mail address 1
Mail address 2
become effective. Verify that it is safe for the Ethernet Unit to restart before
transferring the settings data.
The following Unit settings must be made when using the Mail Send Function.
Setting requirement
Required.
One or the other is required, depending on the Server specifi-
cation type setting.
Rarely required (when a setting other than the default setting of
25 is required).
Required.
Required when the account must be authenticated with POP3
before sending mail.
Required.
One or the other is required, depending on the server specifica-
tion method setting.
Rarely required (when a setting other than the default setting of
110 is required).
Required when the account name is different from the name up
to the @ symbol in the e-mail address.
Required.
Optional (Change when the default setting of 5 minutes is unac-
ceptable.)
Required.
Rarely required (when a setting other than the default setting of
53 is required).
Optional (Change when the default setting of 10 seconds is
unacceptable.)
At least one e-mail address must be entered (mail address 1 or
2).
Section 2-4
Reference
1-4 Common
Protocol Settings
page 21
19