Wi-Fi Advanced Configuration - Huawei HG8240 Service Manual

EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
Parameter
Encryption Mode
l The security mode and encryption configured on a Wi-Fi terminal must be the same as those of an ONT. If
l When two SSIDs are configured, if you modify the information of an SSID, the other SSID will re-choose

5.4.2 Wi-Fi Advanced Configuration

1.
Issue 04 (2011-01-12)
NOTE
the TKIP&AES, or AES encryption mode is not configured on the Wi-Fi terminal, the Wi-Fi terminal may
have an old-version driver. If so, update the driver version.
a channel, causing the service to be interrupted for a few minutes.
In the navigation tree on the left, choose WI-FI > Wi-Fi Advanced Configuration. In the
pane on the right, set the advanced Wi-Fi parameters, including the transmit power,
regulatory domain, and channel, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Indicates the encryption mode for the STA to request access to
the wireless network. The encryption mode and encryption
parameters vary with the authentication mode.
l If the authentication mode is set to Open, the encryption
mode can be set to None or WEP.
l If the authentication mode is set to Shared, the encryption is
WEP.
l If the authentication mode is set to WPA Pre-Shared Key,
WPA2 Pre-Shared Key, WPA Enterprise, or WPA2
Enterprise, the encryption mode can be set to AES, TKIP,
or TKIP&AES.
l If the authentication mode is set to Wi-Fi Protected Setup,
WPS Mode must be set to Pin or Push-button.
NOTE
l Pin indicates the pin-based encryption.
l Push-button indicates the push-button-based encryption.
When WPS Mode is set to Push-button, press the WPS button on
the ONT and press the WPS icon included with the STA within two
minutes, or run the WPS setup program in the STA to install the WPS
software.
Figure
5 Web Page Reference
5-16.
5-17