Route; Default Route Configuration; Static Route Configuration; Figure 5-21 Default Route Configuration - Huawei HG8240 Service Manual

5 Web Page Reference
2.

5.6 Route

This topic describes how to configure the default route and static route through the Web page.

5.6.1 Default Route Configuration

5.6.2 Static Route Configuration

5.6.1 Default Route Configuration
1.

Figure 5-21 Default Route Configuration

2.
5.6.2 Static Route Configuration
1.
5-24
Click Apply to apply the configuration.
In the navigation tree on the left, choose Route > Default Route Configuration. In the
pane on the right, select or deselect the Default Route option button to enable or disable
the default route of the system, as shown in
NOTE
If an ONT fails to find a matching routing entry after receiving a packet, the WAN interface specified
by the default route configuration sends the packet to a network device. Before the default route of
the system is enabled, the WAN interface must obtain the IP address. Therefore, the parameters of
the WAN interface must be correctly set. For details, see
Click Apply to apply the configuration.
In the navigation tree on the left, choose Route > Static Route Configuration. In the pane
on the right, click New. In the dialog box that is displayed, set the parameters related to the
static route, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Figure
Figure 5-22.
Service Manual
5-21.
5.2.1 WAN Configuration.
Issue 04 (2011-01-12)