Huawei HG8240 Service Manual page 163

EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
Issue 04 (2011-01-12)
huawei(config-if-gpon-0/1)#ont alarm-profile 1 1 profile-id 1
huawei(config-if-gpon-0/1)#ont alarm-profile 1 2 profile-id 1
6. Confirm that the ONT goes online normally.
After an ONT is added, run the display ont info command to query the current status
of the ONT. Ensure that Control flag of the ONT is active, Run State is online,
Config state is normal, and Match state is match.
huawei(config-if-gpon-0/1)#display ont info 1 1
---------------------------------------------------------------------
F/S/P
0/1/1
ONT-ID
1
Control flag
activated.
Run state
normally.
Config state
of the
Match state
bound to
actual capability
...//The rest of the response information is omitted.
If the ONT state fails, the ONT fails to be in the up state, or the ONT does not match,
check the ONT state by referring to the above-mentioned descriptions.
– If Control flag is deactive, run the ont activate command in the GPON port mode
to activate the ONT.
– If the ONT fails to be in the up state, that is, Run state is offline, the physical line
may be broken or the optical transceiver may be damaged. You need to check both
the material and the line.
– If the ONT state fails, that is, Config state is failed, the ONT capability set
outmatches the actual ONT capabilities (For details about the ONT actual
capabilities, see Reference of GPON ONT Capability Sets. In this case, run the
display ont failed-configuration command in the diagnosis mode to check the
failed configuration item and the failure cause. Then, rectify the fault according to
actual conditions.
NOTE
If an ONT supports only four queues, the values of 4–7 of the priority-queue parameter in the
gem add command are invalid. After configuration recovers, Config state will be failed.
– If the ONT does not match, that is, Match state is mismatch, the port types and
number of ports undermatch the actual port types and number of ports supported
by the ONT. In this case, run the display ont capability command to query the
actual capability of the ONT, and then select one of the following modes to modify
the ONT configuration:
– Create a proper ONT profile according to the actual capability of the ONT, and
then run the ont modify command to modify the configuration data of the ONT.
– Modify the ONT profile according to the actual capability of the ONT and save
the modification. Then, the ONT automatically recovers the configuration
successfully.
7. Configure a traffic profile.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
:
:
: active //Indicates that the ONT is
: online //Indicates that the ONT goes online
: normal //Indicates that the configuration status
: match //Indicates that the capability profile
3 Configuration
ONT is normal.
the ONT is consistent with the
of the ONT.
3-125