Huawei HG8240 Service Manual page 201

EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
Issue 04 (2011-01-12)
normally.
Config state
of the
Match state
bound to
actual capability
...//The rest of the response information is omitted.
If the ONT state fails, the ONT fails to be in the up state, or the ONT does not match,
check the ONT state by referring to the above-mentioned descriptions.
– If Control flag is deactive, run the ont activate command in the GPON port mode
to activate the ONT.
– If the ONT fails to be in the up state, that is, Run state is offline, the physical line
may be broken or the optical transceiver may be damaged. You need to check both
the material and the line.
– If the ONT state fails, that is, Config state is failed, the ONT capability set
outmatches the actual ONT capabilities (For details about the ONT actual
capabilities, see Reference of GPON ONT Capability Sets. In this case, run the
display ont failed-configuration command in the diagnosis mode to check the
failed configuration item and the failure cause. Then, rectify the fault according to
actual conditions.
NOTE
If an ONT supports only four queues, the values of 4–7 of the priority-queue parameter in the
gem add command are invalid. After configuration recovers, Config state will be failed.
– If the ONT does not match, that is, Match state is mismatch, the port types and
number of ports undermatch the actual port types and number of ports supported
by the ONT. In this case, run the display ont capability command to query the
actual capability of the ONT, and then select one of the following modes to modify
the ONT configuration:
– Create a proper ONT profile according to the actual capability of the ONT, and
then run the ont modify command to modify the configuration data of the ONT.
– Modify the ONT profile according to the actual capability of the ONT and save
the modification. Then, the ONT automatically recovers the configuration
successfully.
6. Configure a traffic profile.
You can run the display traffic table ip command to query the traffic profiles existing
in the system. If the traffic profiles existing in the system do not meet the requirements,
you need to run the traffic table ip command to add a traffic profile.
The profile ID is 10, no rate limitation in the upstream and downstream directions,
the priority is 4, and packets are scheduled according to the priority carried.
huawei(config-if-gpon-0/1)#quit
huawei(config)#traffic table ip index 10 cir off priority 4 priority-
policy tag-In-Package
7. Create service ports.
Set the service port indexes to 5 and 6, SVLAN ID to 1000, GEM port ID to 3, and
CVLAN ID to 30. Use traffic profile 10.
huawei(config)#service-port 5 vlan 1000 gpon 0/1/1 ont 1 gemport 3 multi-
service user-vlan 30 rx-cttr 10 tx-cttr 10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: normal //Indicates that the configuration status
: match //Indicates that the capability profile
3 Configuration
ONT is normal.
the ONT is consistent with the
of the ONT.
3-163