Lan Host Configuration; Dhcp Server Configuration; Figure 5-13 Lan Host Configuration - Huawei HG8240 Service Manual

5 Web Page Reference
2.

5.3.2 LAN Host Configuration

1.

Figure 5-13 LAN Host Configuration

2.

5.3.3 DHCP Server Configuration

1.
5-12
NOTE
If the check box corresponding to the LAN port is selected, it indicates that the LAN port works in
layer 3 mode, that is, the gateway mode; if the check box corresponding to the LAN port is deselected,
it indicates that the LAN port works in layer 2 mode, that is, the bridge mode.
By default, the check boxes corresponding to all LAN ports are deselected, that is, all LAN ports
work in layer 2 mode.
Click Apply to apply the configuration.
In the navigation tree on the left, choose LAN > LAN Host Configuration. In the pane on
the right, set the management IP address and subnet mask of the LAN host, as shown in
Figure 5-13.
NOTE
The IP address of the device connected to the LAN port must be in the same subnet as the management
IP address. In this way, you can access an ONT through the Web page and perform query and
management. You can manually set the IP address of the device connected to the LAN port to be on
the same network segment as the management IP address, or start the DHCP server to set the IP
address in the DHCP address pool to be on the same network segment as the management IP address.
For details, see 5.3.3 DHCP Server
Click Apply to apply the configuration.
In the navigation tree on the left, choose LAN > DHCP Server Configuration. In the pane
on the right, you can configure the LAN side DHCP address pool for the ONT that functions
as a gateway. After the configuration, the PC connected to the LAN port can automatically
obtain an IP address from the address pool, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Configuration.
Figure
Service Manual
5-14.
Issue 04 (2011-01-12)