Table of Contents
Advertisement
6.
Press TOP OF FORM or PAPER ADVANCE to further advance paper into the paper
stacking area. Verify unobstructed paper feeding.
7.
Set the Forms Thickness Adjustment Lever (A) to approximate the paper thickness (1 to 6
parts). If closed too tightly, the shuttle may smear or tear the paper.
8.
Press CLEAR FAULT and place the printer online.
9.
Set the top-of-form as described in the Setting Top-of-Form procedure.
10. Close the printer cover.
11. On floor cabinet models, perform the Paper Stacking instructions to start the paper stack
ing properly.
Unloading Paper
1.
Place the printer offline.
2.
Tear off the paper below the paper guide. On pedestal model printers, this will be at the
bottom of the printer.
3.
Fully raise the Forms Thickness Adjustment Lever.
4.
Open both tractor gates and remove the paper from the tractor sprockets.
5.
Gently pull the paper up through the paper slot. Be careful not to let paper perforations or
sprocket holes catch on the ribbon mask.
Operation
2-13
Advertisement
Table of Contents
