Table of Contents
Advertisement
Figure 10-6. Front Shock Mount Restraint Screw Removal - Floor Cabinet Model
Side Shock Mount Restraint Screw Removal
The remaining four shock mount restraint screws are accessed through the right side of the
printer by removing the right side panel and lowering the card cage. These procedures are de
scribed in this section.
Side Panel Removal - To remove the right side panel, perform the following instructions and
refer to Figure 10-7.
1.
Raise the printer cover.
2.
Disconnect the two ground wire connectors (A) from the corners of the side panel.
3.
Loosen the side panel release screw (B) with the Phillips head screwdriver. Do not re
move the screw; simply loosen it enough to slide in the notched cutout on the frame.
4.
Using both hands, lift the side panel up and out from the bottom edge. The panel fits
snugly on four mounting studs (C). First time removal of the side panel may require extra
pressure to unseat the studs from the panel keyholes (D).
Installation
10-7
Advertisement
Table of Contents
