Cable Connections
Perform the following instructions and refer to Figure 10-15 (floor cabinet model) and
Figure 10-16 (pedestal model) to connect the cables to the printer.
1.
Verify the voltage shown on the printer ID label (A) is the same as the site line voltage.
Refer to the Power Requirements section for more information.
Operator hazard and printer damage may occur if the printer is connected to a
power source for which it is not configured.
2.
Make sure the printer power switch (B) is set to OFF.
3.
Connect the power cord, which is supplied with the printer, between the printer's ac
power connector (C) and the ac line receptacle.
4.
Connect the customer supplied interface cable between the printer's interface connector
(D) and the host computer. Refer to the Interface chapter for a complete description of
the printer interface.
Installation
-
Figure 10-15. Cable Connections - Floor Cabinet Model
WARNING
-
10-17