Table of Contents
Advertisement
Paper Stacking - Floor Cabinet Models
The floor cabinet model is capable of stacking up to one complete box of standard computer
paper when the paper is properly loaded. After loading the paper, perform the following in
structions.
1.
Open the rear cabinet door to access the paper stacking area.
NOTE: Steps 2 and 3 pertain to installation of the two paper stacking fences, the front
fence between the paper stack and the paper supply and the rear fence on the rear cabinet
door. If these fences have already been installed, continue with the paper stacking in
structions at step 4.
2.
If not previously installed, install the front paper fence in the bracket as close as possible
to the paper stacking area as shown in Figure 2-12. The bracket is located in the upper
portion of the printer paper stacking area near the outer edges. The fence must be in
stalled in the same bracket position on each side to maintain a straight vertical orienta
tion.
Figure 2-12. Front Paper Fence Installation - Floor Cabinet Models
3.
If not previously installed, install the rear paper fence on the inside of the rear cabinet
door placing the fence in the brackets at each upper edge of the door and in the bracket
centered on the lower edge of the door as shown in Figure 2-13.
2-16
Operation
Advertisement
Table of Contents
