Reset To Default Settings - Nortel BayStack 450 Using Manual

Using the BayStack 450 10/100/1000 Series Switch

Reset to Default Settings

Caution: If you choose the Reset to Default Settings command, all of your
configured settings will be replaced with factory default settings when you
press [Enter].
Achtung: Bei Auswahl des Befehls zur Rücksetzung auf die
Standardeinstellungen werden alle von Ihnen konfigurierten Einstellungen
durch die werkseitigen Standardeinstellungen ersetzt, wenn Sie die
Eingabetaste drücken.
Attention: Si vous restaurez la configuration usine, votre configuration
courante sera remplacée par la configuration usine dès que vous appuierez sur
[Entrée].
Precaución: Si selecciona el comando Restaurar valores predeterminados,
todos los valores de configuración se sustituirán por las valores
predeterminados en fábrica al pulsar [Intro].
Attenzione: Nel caso in cui si selezioni la reimpostazione dei valori di
default, tutte le impostazioni configurate verranno sostituite dai default di
fabbrica premendo il tasto [Invio].
The Reset to Default Settings option (accessed from the main menu) allows you to
reset a standalone switch, a specific unit in a stack configuration, or an entire
stack, and replace all configured switch parameters with the factory default
values. To view factory default values, see
The Reset to Default Settings option takes approximately 5 seconds to complete.
During this time, the switch initiates a self-test that comprises various diagnostic
routines and subtests. The LEDs display various patterns to indicate that the
subtests are in progress.
3-90
Appendix F, "Default Settings."
302401-D Rev 00