This chapter covers the following topics:
•
•
•
•
•
•
Refer to Chapter 3, "Using the Console Interface," to further configure your
BayStack 450 switch.
Installation Requirements
Before installing the BayStack 450 switch, verify that the package contains the
following items in addition to this guide (see
Note: Be sure that the supplied AC power cord matches the requirements for
your region; see "AC Power Receptacle" on page 1-9.
Install the BayStack 450 switch in a ventilated area that is dust free and away from
heat vents, warm air exhaust from other equipment, and direct sunlight. Avoid
proximity to large electric motors or other electromagnetic equipment. When
choosing a location, observe the environmental guidelines listed in Appendix A,
"Technical Specifications." You will need a Phillips screwdriver for the
installation.
302401-D Rev 00
Installing the BayStack 450 Switch
Installation requirements
Installation procedure
Instructions for connecting power
Instructions for verifying the installation
Instructions for the initial (standalone) switch setup
Instructions for the initial stack setup
Chapter 2
Figure
2-1).
2-1