Display Netbios Filter Settings; Netbios Filter Configuration; Figure 142 Netbios Display Filter Settings Command Example; Table 69 Netbios Filter Default Settings - Nortel BCM50e Configuration

276 Appendix I NetBIOS filter commands

Display NetBIOS filter settings

Figure 142 NetBIOS Display Filter Settings Command Example

============== NetBIOS Filter Status ===============
Syntax:
sys filter netbios disp
This command gives a read-only list of the current NetBIOS filter modes.
The filter types and their default settings are as follows:

Table 69 NetBIOS filter default settings

Name
Between LAN and
WAN
IPSec Packets
Trigger dial

NetBIOS filter configuration

Syntax:
sys filter netbios config <type> <on|off>
where
<type> identifies which NetBIOS filter (numbered 0-3) to configure.
N0115789
Between LAN and WAN: Block
IPSec Packets: Forward
Trigger Dial: Disabled
Description
This field displays whether NetBIOS packets are
blocked or forwarded from the LAN to the WAN or
from the WAN to the LAN.
This field displays whether NetBIOS packets sent
through a VPN connection are blocked or
forwarded.
This field displays whether NetBIOS packets are
allowed to initiate calls. Disabled means that
NetBIOS packets are blocked from initiating calls.
Example
Forward
Forward
Disabled