Trunk Configuration Screen For Switch S2; Figure 1-43. Multilink Trunk Configuration Screen For Switch S2 - Nortel BayStack 450 Using Manual

Trunk Configuration Screen for Switch S2

As shown in
configurations (T2 and T3). Both trunks connect directly to switch S1.
As in the previous screen examples, to set up a trunk configuration, choose
MultiLink Trunk Configuration from the MultiLink Trunk Configuration Menu
screen.
Figure 1-43
Trunk Trunk Members (Unit/Port)
----- ------------------------------- ------------ --------------- ------------
1 [ /25 ][
2 [ /1 ][
3 [ / ][
4 [ / ][
5 [ / ][
6 [ / ][
Trunk Trunk Name
----- ------------------
1 [ S2:T2 to S1 ]
2 [ S2:T3 to S1 ]
3 [ Trunk #3 ]
4 [ Trunk #4 ]
5 [ Trunk #5 ]
6 [ Trunk #6 ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu.
Figure 1-43. MultiLink Trunk Configuration Screen for Switch S2
Switch S2 is configured as follows:
•
•
302401-D Rev 00
Figure 1-40
shows the MultiLink Trunk Configuration screen for switch S2.
MultiLink Trunk Configuration
/26 ][ / ][ /
/3 ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
Trunk (read only) indicates the trunks (1 to 6) that correspond to the switch
ports specified in the Trunk Members fields.
Trunk Members (Unit/Port) indicates the ports that can be configured, in
each row, to create the corresponding trunk:
Ports 25 and 26 are assigned as trunk members of trunk 1.
BayStack 450 10/100/1000 Series Switches
on page 1-59, switch S2 is set up with two trunk
STP Learning
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
Press Ctrl-C to return to Main Menu.
Trunk Mode Trunk Status
Basic [ Enabled
Basic [ Enabled
Basic [ Disabled ]
Basic [ Disabled ]
Basic [ Disabled ]
Basic [ Disabled ]
]
]
1-63