Table of Contents
Advertisement
Table F-1.
Factory Default Settings for the BayStack 450 Switch
Field
Unit
Status
Autonegotiation
Speed/Duplex
Unit
Autonegotiation
Flow Control
Note: The following two fields only appear when a single Phy MDA with a separate redundant Phy port is
installed.
Preferred Phy
Active Phy
Trunk Members (Unit/Port)
STP Learning
Trunk Mode
Trunk Status
Trunk Name
Traffic Type
Monitoring Mode
Monitor/Unit Port
Unit/Port X
Unit/Port Y
Address A
Address B
302401-D Rev 00
Default setting
1
Enabled (for all ports)
)
Enabled (for all ports
100Mbs/Half (when
Autonegotiation is Disabled)
1 to 8 (depending on
configuration status)
Enabled
Disabled
Right
Read-only field indicating the
operational Phy port (Right,
Left, or None)
Zero-length string
Normal
Basic
Enabled
Trunk #1 to Trunk #6
Rx and Tx
Disabled
Zero-length string
Zero-length string
Zero-length string
00-00-00-00-00-00
(no MAC address assigned)
00-00-00-00-00-00
(no MAC address assigned)
(continued)
Appears in this CI screen
Port Configuration
(page
High Speed Flow Control Configuration
(page
3-34)
MultiLink Trunk Configuration
(page
3-39)
MultiLink Trunk Utilization
Port Mirroring Configuration
(page
3-45)
Default Settings
3-32)
(page
3-41)
(continued)
F-3
Advertisement
Chapters
Table of Contents
