Rear Brake Disc Removal And Installation - Suzuki GSX-R600 Manual

Brake Caliper Sliding Pin
Inspect the brake caliper sliding pin for wear and other
damage. If any damage is found, replace the sliding pin
with a new one.
Boot and Spacer
Inspect the boots and spacer for damage and wear. If
any defects are found, replace them with new ones.
Brake Pad Spring
Inspect the brake pad springs for damage and excessive
bend. If any defects are found, replace them with new
ones.

Rear Brake Disc Removal and Installation

Removal
1) Remove the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-11)".
2) Remove the rear brake disc.
I823H1430019-01
Installation
Install the rear brake disc in the reverse order of
removal. Pay attention to the following points:
• Make sure that the brake disc is clean and free of any
grease.
• Apply thread lock to the brake disc bolts (1) and
tighten them to the specified torque.
: Thread lock cement 99000–32130 (Thread
Lock Cement Super 1360 or equivalent)
Tightening torque
I823H1430020-01
Brake disc bolt (Rear) (a): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
I837H1430016-01
1
(a)
Rear Brakes: 4C-6
B837H14306007
I837H1430017-01
1
(a)
I837H1430018-01