Suzuki GSX-R600 Manual page 497

4) Apply grease on the recessed portion of the joint
plate holder (3) and set the joint plate (10).
NOTE
When positioning the joint plate (10) on the
tool, its stamp mark must face the joint plate
holder (3) side.
5) Set the drive chain on the tool as illustrated and turn
in the adjuster bolt (5) to secure the wedge holder
and wedge pin (4).
10
4
5
6) Turn in the pressure bolt [A] (6) and align two joint
pins (8) properly with the respective holes of the joint
plate (10).
7) Turn in the pressure bolt [A] (6) further using the bar
(7) to press the joint plate over the joint pins.
8
10
3
I649G1310031-02
6
7
I837H1310030-01
Drive Chain / Drive Train / Drive Shaft:
8) Continue pressing the joint plate until the distance
between the two joint plates comes to the
specification.
Joint plate distance specification "a"
18.6 – 18.9 mm (0.73 – 0.74 in)
CAUTION
!
If pressing of the joint plate makes the
dimension out of specification excessively,
the work must be carried out again by using
new joint parts.
"a"
Joint pin staking
1) Set up the special tool as shown in the figure.
5
4
1. Tool body
2. Grip handle
3. Pressure bolt [A]
4. Adjuster bolt (Without hole)
5. Staking pin (Stowed inside grip handle behind rubber cap)
6. Bar
NOTE
Before staking the joint pin, apply a small
quantity of grease to the staking pin (5).
I649G1310033-03
3
1
2
6
I649G1310034-02
3A-9