Suzuki GSX-R600 Manual page 273

• Install the PAIR reed valves (1) along with the
gaskets.
NOTE
Fit the projection of the gaskets to the
depression of the camshaft holders.
CAUTION
!
Replace the gaskets with new ones.
1
• Install a new gasket to the cylinder head cover.
• Apply bond to the cam end cap points of the gasket as
shown.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
CAUTION
!
Use a new gasket to prevent oil leakage.
• Place the cylinder head cover on the cylinder head.
• Fit a new gasket (2) to each head cover bolt.
CAUTION
!
Use new gaskets to prevent oil leakage.
• Apply engine oil to both sides of the gaskets.
• Tighten the head cover bolts (3) to the specified
torque.
Tightening torque
Head cover bolt (a): 14 N·m (1.4 kgf-m, 10.0 lb-ft)
I837H1140235-01
• Install the spark plugs. Refer to "Ignition Coil / Plug
Cap and Spark Plug Removal and Installation in
Section 1H (Page 1H-6)".
• Install the following parts:
– Air cleaner box
(Refer to "Air Cleaner Box Removal and Installation
(Page 1D-7)".)
– Throttle body
(Refer to "Throttle Body Removal and Installation
I837H1140236-01
(Page 1D-10)".)
Engine Mechanical:
2
I837H1140237-01
3
(a)
3
(a)
I837H1140238-01
1D-33