Oil Pressure Switch Removal And Installation; Oil Pressure Switch Inspection; Ignition Switch Inspection - Suzuki GSX-R600 Manual

9C-7 Combination Meter / Fuel Meter / Horn:
4) Check if the oil pressure indicator (LED) (2) will light
up and LCD (3) will flicker when grounding the lead
wire (1).
If the oil pressure indicator does not light up, replace
the combination meter assembly with a new one
after checking the connection of couplers.
1

Oil Pressure Switch Removal and Installation

Refer to "Oil Pressure Switch Removal and Installation in
Section 1E (Page 1E-9)".

Oil Pressure Switch Inspection

Inspect the oil pressure switch in the following
procedures:
NOTE
Before inspecting the oil pressure switch,
check if the engine oil level is correct. Refer
to "Engine Oil and Filter Replacement in
Section 0B (Page 0B-10)".
1) Remove the left side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-11)".
2) Disconnect the oil pressure switch lead wire from the
oil pressure switch.
3) Inspect the oil pressure switch for continuity with the
tester. If any abnormality is found, replace the oil
pressure switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
Position
ON
(Engine is at stop.)
OFF
(Engine is running.)
4) After finishing the oil pressure switch inspection,
reinstall the removed parts.
3
2
I837H1930014-04
B837H19306013
B837H19306014
G/Y Ground
I823H1930033-01

Ignition Switch Inspection

Inspect the ignition switch in the following procedures:
1) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-7)".
2) Disconnect the ignition switch lead wire coupler (1).
3) Inspect the ignition switch for continuity with a tester.
If any abnormality is found, replace the ignition
switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
E-02, 19, 24
Color
R
Position
ON
OFF
LOCK
P
E-03, 28, 33
Color
R
Position
ON
OFF
LOCK
P
4) After finishing the ignition switch inspection, reinstall
the removed parts.
B837H19306015
1
I837H1930015-01
O Gr Br
I823H1930019-02
O O/Y Gr Br
I837H1930021-01