Suzuki GSX-R600 Manual page 433

• Tighten the EXCV cables mounting nuts to the
specified torque.
Tightening torque
EXCV cable mounting nut (d): 5.5 N·m (0.55 kgf-
m, 4.0 lb-ft)
• Install the connector (2).
CAUTION
!
Replace the connectors with new one.
NOTE
• When installing a new connector, remove
all of the old sealer from the exhaust pipe
and muffler. Apply the exhaust gas sealer
to both the inside and outside of the new
connector.
• The chamfer side "A" of connector (2) face
the muffler.
: Muffler seal (MUFFLER SEAL LOCTITE
5920 (commercially available) or equivalent)
"A"
(d)
I837H11B0015-01
2
I837H11B0016-01
• Tighten the muffler mounting nut (3) and muffler
connecting bolt (4) to the specified torque.
Tightening torque
Muffler mounting nut (e): 25 N·m (2.5 kgf-m, 18.0
lb-ft)
Muffler connecting bolt (f): 23 N·m (2.3 kgf-m,
16.5 lb-ft)
3
(e)
Exhaust System Inspection
Inspect the exhaust pipe connection and muffler
connection for exhaust gas leakage and mounting
condition. If any defect is found, replace the exhaust
pipe assembly or muffler with a new one.
Check the exhaust pipe bolts, muffler connecting bolt
and muffler mounting bolt are tightened to their specified
torque. Refer to "Exhaust System Components
(Page 1K-5)".
Exhaust System: 1K-14
4
(f)
I837H11B0017-03
B837H11B06003