Suzuki GSX-R600 Manual page 299

7) Tighten the conrod cap bolt by using a 10 mm, 12
point socket wrench in the following two steps.
Tightening torque
conrod cap bolt: 15 N⋅m (1.5 kgf-m, 11.0 lb-ft)
then turn in 1/4 (90°) turn
" a "
"a": 90°
8) Apply engine oil to the conrod big end side surfaces.
9) Check the conrod movement for smooth turning.
10) Apply engine oil to each crankshaft journal.
11) Insert the right and left-thrust bearings with the oil
grooves "A" facing towards the crankshaft web.
NOTE
• Right-thrust bearing has green painting.
• Inspect and select the crankshaft thrust
clearance if necessary. Refer to
"Crankshaft Thrust Clearance Inspection
and Selection (Page 1D-79)".
I837H1140114-01
Transmission
Install the transmission. Refer to "Transmission
Installation in Section 5B (Page 5B-5)".
I837H1140134-01
I837H1140136-01
Engine Mechanical:
"A"
1D-59
"A"
I837H1140137-02
I837H1140138-01
I837H1140139-01