Startup - Konica Minolta DRYPRO Model 793 Operation Manual

Ch.3 Operation

3-2 Startup

How to start up the DRYPRO 793 is detailed below.
2
DRYPRO Vstage MODEL 793 Operation Manual Ver.1.01 2005.1
1
Turn ON the power breaker located on the right
side of the DRYPRO 793.
ON
OFF
2
Press and hold the [Operation] button on the
Control Panel for approx. 1 sec.
- "Initializing" screen will be displayed.
- Starts initializing of the DRYPRO.
- Upon completion of initialization, "Warming Up" screen will
be displayed.
- Upon completion of warmup, "READY" screen will be
displayed, and the device is ready to print.
< 30 >
Pressing the [Operation]
button again will shut
down the power. In this
case, press the button
again to start up.
Print operation is dis-
abled during warming
up, however, it is possi-
ble to receive the data
from the diagnostic
device. Received data
will be printed after the
device becomes ready to
print.
It is possible to switch
between the Menu mode
and the Maintenance
Mode even during warm-
ing up.
It takes approx. 25 min-
utes before it reach
print-ready status.
However, this varies
depending on the sea-
son or room tempera-
ture.