Startup Options; Auto Continue; Hold Job Timeout - Konica Minolta magicolor 7450 Service Manual

Field Service Ver. 1.0 May 2006
C. UNIT OF MEASURE
Function • Sets the measurement units for CUSTOM SIZE mode.
• Sets the measurement units for SYS DEFAULT MENU/DEFAULT PAPER/CUSTOM
SIZE mode.
Use • To change media measurement units.
Setting For North America
/procedure • The default setting is INCHES.
For other destinations
• The default setting is MILLIMETERS.
9.8.4

STARTUP OPTIONS

A. DO STARTUP PAGE
Function • Sets whether a startup page is printed at startup of the printer.
• To specify whether a startup page is printed.
Use ON : Start up page is printed at startup the printer.
OFF : Start up page is not printed at startup of the printer.
Setting • The default setting is ON.
/procedure
9.8.5

AUTO CONTINUE

Function • At the time of the following Operator Call, continues auto printing by ignoring the
media type or size.
• "PAPER EMPTY" (except "MANUAL FEED"), "xxxx SIZE ERROR", "xxxx TYPE
ERROR".
Use • To specify whether printing should continue when the specified media size and type
are not available.
ON : Auto continuous printing is ON.
OFF : Auto continuous printing is OFF.
Setting • The default setting is OFF.
/procedure
9.8.6

HOLD JOB TIMEOUT

Function • Sets the amount of time before a job saved temporarily in the printer is automatically
deleted.
Use • To change the amount of time a job is held before being deleted.
Setting • The default setting is DISABLE (No auto delete.).
/procedure
"DISABLE"
NOTE
• This menu is available only when an optional Hard Disk Kit is installed.
INCHES
"ON"
ON
1 hour 4 hours
MILLIMETERS
OFF
"OFF"
1 day 1 week
9. Menu
127