POWER TRIM
Oil Pump Installation
1. Install spring, ball, lubricated O-ring and plastic seat to manifold.
2. Check to see that O-rings are placed on bottom of pump.
3. Install filter and filter seal under pump. Install pump onto manifold. Torque screws to spe-
cified torque.
a -
b -
Pressure Operated Assembly Installation
IMPORTANT: Inspect poppet assembly for debris in the area shown. If debris is found
on poppet, replace poppet.
a -
b -
1. Lubricate O-rings.
Page 5C-46
b
Screw (3)
Suction Seat Assembly
Screw Torque
70 lb-in. (7.7 Nm)
Debris Under Valve Tip
Rubber Seat
a
a
b
90-828631R3 MARCH 1999