OIL INJECTION
Oil Pump Removal and Installation
REMOVAL
1. Disconnect the wiring harness from the pump.
2. Disconnect the oil hoses.
3. Remove three bolts and remove pump.
h
a -
b -
c -
d -
e -
g -
h -
INSTALLATION
1. Install pump as shown.
2. Reconnect the oil hoses. Refer to Oil Injection Hose Installation for correct location.
Fasten hoses to pump fittings with sta-straps.
3. Connect the wiring harness.
NOTE: Replacement oil pump may have 2 pin electrical connection vs. 4 pin with original
oil pump. The 2 pin connection will still function with the existing wire harness.
4. Refill the oil system. Refer to Priming the Oil Pump.
Page 3C-10
Oil Pump
Gasket
Bracket
Bushing (3)
Rubber Grommet (3) – Insert into Hole
f -
Washer (3)
Bolt (3) – Torque to 16 lb. ft. (21.5 Nm)
Sta-Straps – Fasten All Hose Ends
a
c
b
e
f
90-855347R1 JANUARY 1999
d
g