1. Place the outboard in "Forward" gear and check timing at idle "Retarded." (If not within
specification window, refer to Diagnostic Test Procedures Section 2A.)
a -
2. Slowly increase the engine rpm while watching the ignition timing marks. The timing
should increase to the maximum timing specification "Full Advance" at approximately
2500-3000 RPM. (If not within specification window, refer to Diagnostic Test Procedures
Section 2A.)
a -
90-828631R3 MARCH 1999
Timing Mark (Full Retarded)
a
Timing Mark (Full Advance)
TIMING, SYNCHRONIZING, & ADJUSTING
5
a
50 hp
40/45 hp
25
35
Page 2C-11