Punch Unit Horizontal Position Adjustment - Konica Minolta bizhub 601 User Manual

Utility mode
8
Use a Punch setting to print another sample copy.
9
Check the print result.
– Check that the horizontal position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.6.6

Punch Unit Horizontal Position Adjustment

The horizontal position of punched holes when printing with a Punch setting can be adjusted.
Note
[Punch Unit Horizonal Position Adjustment] appears only if optical Z folding unit is installed.
For details on the Punch settings, refer to
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [6 Punch Unit Horizontal Position Adjustment].
The Punch Unit Horizontal Position Adjustment screen appears.
6
Check the horizontal position of the punched holes.
– To increase width A, touch [+] to increase the adjustment (between 0.1 mm and 5.0 mm).
751/601
"Punching holes in copies (Punch settings)" on page
11-36.
"Displaying the Administrator
11
2-62.
11-47